|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Help!!! posted by Bullet on April 13, 2007 at 08:37:57:
There is a second pair of sockets on the Mid/Tweeter section of the input panel, where a jumper should be in place. This jumper is to be replaced by a resistor if the treble output is too high. The tweeters will not work if the jumper is missing or corroded.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Are you sure the tweeter attenuator jumpers are secure? - Al Sekela 15:28:34 04/13/07 (1)
- Re: Are you sure the tweeter attenuator jumpers are secure? - Bullet 10:59:15 04/14/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
