|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: 3.6 ribbon replacement posted by The Tick on April 1, 2007 at 17:55:51:
Hey, Tick, just did one myself a couple of months ago. Was fretting like you were. No worries. In fact, the tubing Magnepan uses to ship the tweeter is kind of a pain (along with the 20 or so screws securing the tweeter assembly to the speaker mdf) - so just remember when unpacking to be firm but gentle. And remember to be careful when attaching the connectors as Dimitry says because the connectors on the tweeters are rather maleable and can break off if you use too much force. And, of course, serial numbers at the bottom as Al points out. The tweeters will, of course, arrive with protector strips on them so don't remove them until you're completely done with the R/R. After the R/R don't forget that the ribbon will need a while to break in so it may sound different from your other Maggie. Good luck.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 3.6 ribbon replacement - Webnick 12:47:39 04/02/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
