In Reply to: Re: Wiring to internal drivers posted by newtonnjd on March 13, 2007 at 11:13:02:
No, I wouldn't go back in there for that, the sock is too hard to work with.
The spades have a little locking piece that snaps down in a hole in the tab, so you have to pry it out of that hole with a small screwdriver, then it comes off easy.
Thats the same hole I enlarged to solder my wires through.I didn't put the 14g DHLabs under the tab as it being so thick the little tab screw couldn't handle it.
AB.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Wiring to internal drivers - ABliss 12:27:25 03/13/07 (0)