In Reply to: Re: Wiring to internal drivers posted by ABliss on March 12, 2007 at 20:14:04:
When I rewired my MG12s using single strands of magwire, I just unscrewed the tabs a little without removing them, made a hook shape of the stripped end of the magwire, slipped it underneath the tab, then screwed it down tight again. No soldering. I could not seem to remove the spades terminating the old crossover wire, so just cut the wire off and left the spades as they were.Is it worth going back under the sock to get rid of these spades, and if so, how are they removed?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Wiring to internal drivers - newtonnjd 11:13:02 03/13/07 (1)
- Re: Wiring to internal drivers - ABliss 12:27:25 03/13/07 (0)