In Reply to: Bi-amping 1.6s posted by Sebrof on October 31, 2006 at 13:37:58:
Hi Mike,The spec sheet says the crossover is at 600Hz. You haven't specified how many wpc into 4 ohms the Sunfire is, so it's hard to give you a specific recommendation for power required for the mid/tweeter amp. Not less than 75% of the Sunfire, I would say.
The most important thing is that the amp should have about the same gain as the Sunfire ... otherwise you get a mismatch on the volume level of each driver. Yes the best situation is to have EXACTLY the same gain (which is what I have with my IIIa 3-way active setup) but if, say, the Sunfire had a gain of x30 then anything from 28-32 would do for the other amp.
You will get a better sound out of the 1.6s if you actively bi-amp ... and then you would normally have a band gain control with this, which means that amp gain mismatches can be corrected.
Regards,
Andy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Bi-amping 1.6s - andyr 17:40:26 10/31/06 (5)
- Re: mismatch on the volume-two methods. - powermatic 05:42:30 11/01/06 (0)
- Re: Bi-amping 1.6s - Sebrof 18:19:21 10/31/06 (3)
- Re: Bi-amping 1.6s - andyr 18:38:50 10/31/06 (2)
- Do they use logarithms in Oz? - neolith 23:32:17 10/31/06 (1)
- Thanks, neo ... - andyr 01:12:40 11/01/06 (0)