In Reply to: Re: Removal and replacement of the crossover pins on Maggie 3.6 posted by andyr on October 23, 2006 at 03:02:24:
Andy, Good call on the smaller gauge wire for the tweeter attenuator. When I first got my Mags, I got a couple inches of 12 ga and crimped some bananas on them figured it had to be better than the steel. EEHHHH not so much. I figured Magnepan had voiced it with the steel so let it be, but later tried some teflon coated 18 ga and that was the ticket. Even with the Cardas kit, they use thicker wire for the x/o and skinny wire for the tweeter.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Removal and replacement of the crossover pins on Maggie 3.6 - onemug 06:56:52 10/24/06 (0)