|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Maggie 1.6 QR - replacing outer covers posted by frankz50 on October 4, 2006 at 20:52:55:
You need to use a small flat-headed screw driver. Insert it into the top(or bottom) between the speaker and the trim and tap it with a hammer until the end of the strip comes loose. Then work your way down the strip loosening it as you go along with the screwdriver. Be careful not to tear the fabric. You'll want to keep track of where all the trim pieces go so you can reuse the same holes when you reinstall them.
s.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- They're nailed in with brads.... - stevenk 04:22:43 10/05/06 (1)
- Thanks -- got it! - frankz50 10:46:04 10/07/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
