|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: Re: Output transformers - which model? posted by KevinC on June 28, 2005 at 20:34:27:
Hi Kevin,Thank you very much for your reply!
You wrote:
>What maximum signal level do you anticipate at the output of your >crossover needed to drive your amps?Well, I must admit that I can not answer this question very specificly, but I can tell you this: At the moment I do not use a Behringer, but a conventional preamp with a built-in fixed-value active crossover. Besides the crossover function the concentional preamp only acts like a "buffer" with 0 dB gain in the line stage, and this is surely enough to drive my amps.
So, zero gain is ok. As far as I know the Behringer should not add any gain by itself, so I assume that the situation is similar to the current one using a conventional preamp.
I further intend to use either the adjustable level controls from the Behringer or fixed analogue resistors (should be better) at the output of the Behringer in order to match the levels between "high" and "low".
I can see that I am not very specific, but I hope that this is sufficient to provide a specific suggestion between the different output transformer models.
I thank you again and hope you can help me further! Thanks!
Regards
Peter
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Output transformers - which model? - pk 07:06:18 06/29/05 (2)
- Re: Output transformers - which model? - KevinC 09:34:37 06/29/05 (1)
- Thanks a lot for your reply, Kevin! (nt) - PK 23:47:31 06/29/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
