In Reply to: M100 with All Film Capacitor Power Supply posted by Guarnera on April 1, 2010 at 08:01:40:
Yes that's the one. What I thought I would do is attach aluminum plates to the sides raising the amp up a couple of inches, and attaching a plate to the bottom of that. Essentially adding a basement to the housing. On this plate I thought I could mount the Power Supply, the Active Bias supply modules and the Film Caps to replace the 47uf caps on the board. However, like I said before, if the 47uf caps on the board are actually part of the power supply it would be more complicated to replace the power supply then if not. So are the 47uf electrolytic cap on the brd part of the power supply or not? Is this possible to do at all? I love my Ella, but would like to upgrade her some.
Tony G
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: M100 with All Film Capacitor Power Supply - Guarnera 08:14:03 04/02/10 (1)
- RE: M100 with All Film Capacitor Power Supply - Thorsten 20:59:22 04/02/10 (0)