In Reply to: DAC Output Stage - a few questions on implementation! posted by Mikey on December 29, 2009 at 20:24:44:
Yes. A configuration for the PCM1794 is covered in the manual as linked.
The wiring diagram is on page 22. This is for a balanced outputs and requires two Universal Tube Stages.
For single ended output simply only connect the negative outputs from the the DAC to the UTS and connect the unused current output to ground via 22 Ohm. Only one UTS is then required.
DIY - Done Right!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: DAC Output Stage - a few questions on implementation! - bcherry 16:24:24 12/30/09 (11)
- RE: DAC Output Stage - a few more questions.... - Mikey 16:54:44 12/30/09 (10)
- RE: DAC Output Stage - a few more questions.... - bcherry 21:17:09 12/30/09 (9)
- DAC Output Stage - order placed! - Mikey 08:13:26 12/31/09 (8)
- RE: DAC Output Stage - order placed! - bcherry 16:53:41 01/02/10 (7)
- Thanks Brian! I found a perfect spot... - Mikey 08:29:45 01/04/10 (6)
- RE: Thanks Brian! I found a perfect spot... - bcherry 04:53:53 01/05/10 (5)
- UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Mikey 08:50:05 01/18/10 (4)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Thorsten 08:41:15 01/19/10 (0)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - bcherry 01:47:49 01/19/10 (2)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Gnnett 21:53:58 01/23/10 (1)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - bcherry 21:56:25 01/24/10 (0)