Dynaco-Doctor Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Return to Dynaco-Doctor Forum


Message Sort: Post Order or Asylum Reverse Threaded

Dynaco Mark 3's/ Cap Board

76.179.14.9

Posted on June 10, 2016 at 22:58:00
Posts: 1253
Location: Maine
Joined: August 16, 2011
Hi, this might not be the place to ask this question but I have to try.
I have every thing ready to start rebuilding a pair of Dynaco Mark 3's. I bought these cap boards from a guy named Chart Chong. I am having a little communication problem with him. He is trying to help but does not seem to understand a couple questions I have with 3 resistors and a transformer wire.
Without getting into it too far I am asking if anyone has ever tried installing Chart Chongs, Audio Sound Lab V...211C. I do know Joe Curio has his mods here but I had to ask because I don't know where else to go. I have the manual,schematic, his installation instructions, and all his directions but have just a few questions. I think he gave up on me.
Thanks you Dyna Mark 3 fans.......sincerely Mark Korda...kordamark@gmail.com 207-632-1648

 

Hide full thread outline!
    ...
RE: Dynaco Mark 3's/ Cap Board, posted on July 9, 2016 at 05:39:03
xaudiomanx
Audiophile

Posts: 3647
Joined: August 16, 2004
If you could post the schematic of the board it would be helpful. A picture of the board would be better. It can't be too hard if it is a three or four section cap board. The resistors help to isolate the sections.

 

Page processed in 0.013 seconds.