|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
172.220.61.59
In Reply to: RE: Dang...the hole isn't threaded posted by Byrd69 on October 24, 2020 at 10:22:26
you're overthinking this IMO, do the brass washers with O rings mod & be happy ... a dibble of silicone between the washers to damp and cohere will help ... I'd wager you'll not revisit this project in your lifetime
with regards,
Follow Ups:
You're right.
...a few trips back and forth to the garage and it's done, for the time being.
It's level, the suspension has a good amount of play, the posts are not way out of whack from each other, and it turns nice. I can tell there's some weakening of the springs but I'm able to adjust for it.
Time to oil it up and put it into play. I'll be selling it, so I'll pretty up the cob job so it doesn't look so much like a cob job.
Your interest may vary but the results are the same (Byrd 2020)
I can't compete with the dead. (Buck W. 2010)
Cowards can't be heroes. (Byrd 2017)
sweet!
if you can shrink wrap those washers it will look like the factory did it!
with regards,
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: