|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
67.253.54.149
In Reply to: RE: Ceramic Phono Input posted by Eli Duttman on February 11, 2017 at 12:06:24
Hi Eli, thanks for the tip. I checked the site you gave me but could not find the plugs. I'll do some more searching. In the past I would use Phoenix Gold cables. They were gold plated and had the plug end molded right on to the wire so they never would come apart or loosen at that junction. With a sharp knife I could shave the plug part down so they would fit beside each other with no strain.They were gold and cheap but well made. Thanks Eli, the search continues...Mark K.
Follow Ups:
Some "deep" links at MarkerTek follow. Your browser has to temporarily allow all the java scripts MarkerTek employs.
http://audio-video-supply.markertek.com/search?w=nys352&sitepref=1
http://www.markertek.com/product/f-10/canare-f-10-deluxe-clamp-and-body-rca-plug
http://www.markertek.com/product/2549/mogami-2549-2-conductor-microphone-cable-22awg-per-foot-black
Eli D.
Hi Interstage,
Thanks again for your help. When I looked at the schematic it takes a simple change of a cap. and resistor to mirror image the tuner and aux. section more or less just like you said. If I change the ceramic jack to the values of the other tuner and aux. I think I'll be ok. .....Mark K.
Calling Eli,
Hi Eli,
Instead of installing new gold jacks on some tight spaced vintage jacks I want to build a new set of cables with the stuff you recommended. My old jacks will be shine inside and out and be taut with some needle nose work.
I hate to sound like a dope but the Mogami wire has 3 inside wires not 2. Do 2 go to the ground spade or 1 to the ground spade and 1 to the copper braid with the strain crimper? I have not seen the wire yet and am thinking in co-axial terms. Thanks Eli or anyone else....Mark Korda
That third wire, the copper one is the shield, which should be connected at one end only. You connect the shield at the source end except for phono, where you connect it at the destination.Dave
Edits: 02/19/17
Hi Crazy Dave, thanks for the info. I saved you one of those crazy AR dust covers.Not quite done because of constant shoveling up here in Maine but right behind me in my projects to do pile...thanks bud...Mark K
Very cool but my 2 AR's both have the factory dust covers!
Dave
Hey Eli, I found them. Parts Express, slim and sleek and shiny.I'm ordering some tonight...thanks Eli. David D., I'll check that ceramic cartridge site out tonight. 2 problems about to be solved because of all of your help guys.....thanks again...Mark K.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: