![]() ![]() |
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
Hi folks,
I have a pair of silverline sonata's (version 1) which i like very much, but i'm thinking of building up a new set of crossovers for them. I don't know a great deal about electronics, so i was thinking i would just replace the components value-for-value with best of breed components (e.g. hovland musicaps). I will also build them as outboard units, and rewire the drivers. Does anyone have any experience with this sort of thing and would like to offer advice and/or recommend components etc.Thanks in advance, Alex.
What you propose is pretty common. However, a loudspeaker is a synergistic endeavor. Just swapping components may not get you the dramatic improvements you're looking for. If you want to preceed, I'd take the crossovers outboard first. It may not make a dramatic sonic improvement, but it will sure make tweaking it a lot easier. I'd start with the tweeter capacitor. Replacing it will be relatively cheap since it's probably a small value (less than 10uFd). Everybody has their favorite but Auricaps and Musicaps are a good bet. If (god forbid) there are any electrolytic caps on the board, bypass them with small-value film types. Then I'd scout the crossover for any sand cast resistors and replace them with non-inductive types. Sit on this arrangement for a while and digest the changes (if any). Then decide on where to go after that.
Thanks very much, i'll start moving in that direction. Do you have any suggestions for sourcing these components on the web? I've seen a few sites, but as they say, 'on the internet no one knows you are a dog', so I'm wondering if you have had any particularly good experiences.
I've had very good service from Parts Express, Northcreek Music, and Madisound.http://www.madisound.com
http://www.partsexpress.com
http://www.northcreekmusic.com
Thanks very much. FYI, I had a proper look at the crossovers on the weekend, and was surprised to see how simple they were, just 2 inductors and a cap...
This post is made possible by the generous support of people like you and our sponsors: