|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.81.164.49
In Reply to: RE: Changing the Gain posted by Tre' on March 19, 2017 at 07:51:14
I give up. I guess it is too much to expect people to read before answering.
Follow Ups:
Take a 6sn7
250 volt plate
22k plate resistor
8ma.
About 1k bypassed cathode resistor
Gain 14, DB gain 22.9
Now take a 6sn7
250 volts plate
11k plate resistor
8ma.
about a 1K bypassed cathode resistor
Gain of 11.25, DB gain of 21
That's a gain difference of 1.9db.
That's not enough to make any real difference if he's fighting a situation of "too much gain" but the harmonic distortion will be much higher with a 11k plate resistor vs. a 22k plate resistor.
Am I missing something?
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Gain of a 6SN7 using a CCS is pretty much the mu of the tube (assuming it's not driving much load of course).
OTOH Gain of 6Sn7 with unbypassed cathode R of 1K and a low 11K plate resistor is only around 13db according to Spice compared to approx 20db bypassed. And, distortion is approx 10db less than using a 22K despite the lower plate R.
I'm not saying this is the way to go but pointing out that gain can be significantly reduced using tried and tested methods.
Personally I don't like using Rs or Cs in the cathode and prefer to lightly load the plate but many report they love the sound of an unbypassed cathode R. It is a valid (possible) option that just might meet the poster's needs and therefore worthy of putting forward.
From a technical standpoint the combination of a lower plate R, and unbypassed cathode R can significantly reduce gain without increasing distortion. Whether one likes the sound is another thing.
Naz
I agree with your points but Victor said,
"For those who believe that no feedback is better than any feedback, you can reduce the gain by reducing the plate resistor value. Gain directly depends on it."
I was just pointing, without resorting to feedback, lowering the gain of a stage by reducing the value of the plate resistor is not a practical solution. And simply reducing the value of the plate resistor does not lower the gain of the stage to any appreciable amount.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: