|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
108.67.99.115
In Reply to: RE: lesson learned-don't try to be too tricky! posted by vinnie2 on August 04, 2017 at 15:59:43
...depending on how you strap the filament. Or maybe I didn't understand your comment about 6V vs 12V for filament thus driving your attempt to use 6N1P.
Follow Ups:
Still not to late. How do you do it? That makes it even more of a lesson!
Edits: 08/04/17
You would connect one wire from your 6.3V source to the centertap of the 12AT7 filament, and the other wire to both ends of the filament tied together.
--------------------------
Buy Chinese. Bury freedom.
By placing the two halves of the heater in parallel the heater runs on 6.3 volts.
Pins 4 and 5 get tied together for one connection and pin 9 is the other connection.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: