|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
71.29.32.240
In Reply to: RE: voltage drop posted by FlaCharlie on May 31, 2017 at 09:20:01
My reply was incorrect and I edited it. Please read the corrected version.
Follow Ups:
I see. I was going by the schematic, which shows the resistor between the OT and the plate.
I didn't notice the pic with all the extra wires connected up by the cap. All those should really be moved below deck.
As Tre mentioned, the resistor should be soldered as close as possible to the G2 pin. I presume the other wire coming off the caps of the driver tubes is going to the 0.1 coupling cap. That can be moved underneath too. Just connect it to the same place as the other end of the wire going to the cap and remove the wire. The result will be much cleaner looking and safer.
Please see my "update" post above. I believe there is a reason I can't do that.
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: