|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
172.220.61.59
In Reply to: RE: Nobody Using Springs Here? posted by mitch2 on September 16, 2020 at 20:23:32
nice work! what are your before and after vibration measurements?
be well,
Follow Ups:
Ok, now that I have added the "Vibration Analysis" app to my iPhone, I need to decide what specific signal to be used to compare vibration readings for different speaker footers - springs, Herbie's, and spikes. Any suggestions?
probably the speaker cabinet resonance vs. the floor in close proximity
or scope out the link for some ideas on determining isolation boundaries
with regards,
His DIY 705 reminds me of the EVP pads everyone raves about. I suspected those might be Owens Corning 705 with a piece of sheet steel on each end and sandwiched between rubber. I would like to try them.
If I were to DIY EVPs, I might use a slice of thin carbon fiber on each end of the 705 sandwiched between a thin, flat section of 70 duro sorbothane. The EVPs needed for my heavy speakers are about $105 each.
Have not taken measurements yet but they sound good. The heatshrink noticeably damped the rebound so there are less oscillations after they are manually excited by pushing on them. The heatshrink also improves the visual appearance. The holes were necessary to prevent an air lock inside of the springs.
they look good and it's innovative
looking forward to your follow up on measurements
regards,
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: