|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
70.75.247.52
In Reply to: RE: How long did you run them in before hitting them with high voltage? posted by aknaydenov on February 10, 2017 at 15:06:59
Well I do know when more current is needed the tubes will light up a lot more blue. When I use them on my headphone amp, they glow much brighter then on my Preamp.
I have seen on you tube where some old theather amps with MV tubes are glowing bright then lower then brighter again. like the tubes are dancing to the music
I think it happens when some good musical peaks happen as you said when some real lows freg. I won't worry about it.
Just so you know the globe 866 tubes seem to sound more musical, except for Unighted brand, they suck. RCA one are very nice.
I like your diffusers panels in your room.
Follow Ups:
I have 866's in my 6CB5A amps. The filter is single stage L-C, and there is a big flash when the plate transformer gets power to its primary. They are Class A, PP so there is no variability to the observed glow...though selecting tubes with a larger shield to anode gap leaves a bit more of the blue cream floating around in the envelope...:) I would love to find some un-shielded globes.
cheers,
Douglas
Friend, I would not hurt thee for the world...but thou art standing where I am about to shoot.
When I first put new to me MV tubes in my system, I run them for about 30 min. Then I hit the high voltage switch to light them up. Yes the ones that are shielded show less glow.
But keep your eyes open for the earlier 866 tubes with no shield, sometimes on eBay or some tube dealers, they really have that beautiful full blue glow.
I just got some ( in the mail ) nice early 872 tubes with no shield, as well I have an early Deforest type 872 tube with no shield and they are very sweet.
Also addind a choke to the the plate of the 866 tubes does 2 things, it makes sure they each get the same current, also the best thing is the sound quality improvement with the choke on the plate. With the 866 type tube I have used anywhere from 60 my at at least 500 ma, to 1 h choke. The triad 320 my at 500 ma does a very nice job and are very reasonable cost.
A very good improvement with the choke on the plate.
I had only one failure. It was a Taylor glob, and I ran heater power for an hour. When I ran AC through it, cathode coating would get blown off in little sparks. Not sure what had happened; by the time an hour was up, the bottom of the envelope was goated in Hg, and the rest of the glass was clear...
cheers,
Douglas
Friend, I would not hurt thee for the world...but thou art standing where I am about to shoot.
I have had a number of rectifiers that the cathode coating came off. But they still worked well afterwards. I have a number of 249C tubes like this.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: