|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
96.240.131.158
In Reply to: RE: Upgrade? posted by kev.pfeifle on March 06, 2016 at 10:05:09
No really weak link in your system so at some point an amp upgrade could be a next step. My sense is that the Decware (which I have heard, however I have not heard the MP301) will sound somewhat better overall but both amps are similar type SE pentodes with fairly modest power supplies. I think it would be more of a lateral move than the type of difference you want when moving to a new amplifier.I would probably hang on to your current amp and try to hear some SE DH triodes (2A3s, 300Bs etc) and consider moving up this way at some point.
Edits: 03/06/16Follow Ups:
Thanks TubeDriver, that's very helpful information!
If your speakers are really 95dB sensitive and if the average 8 Ohm load is "friendly" (impedance at specific frequencies does not fall down to, say, 4 Ohms or less, there are no sharp negative phase angles, and the load does not consistently rise or fall as a function of frequency), you probably use a 2A3 tube amp in SE without any porblems and a 300B amp in SE for sure. I run 0.8W SE amp on a tube-friendly, 95dB sensitive set of speakers in a small room!
Go for a 2a3 amp if you can find a good one. Excellent call. Better sound to my ears than 300B and could be cheaper.
For 95 dB, I agree.
If the OP has it in his budget, he should simply get a new Serious Stereo 2A3 amp, and be DONE with amplification.
Jeff Medwin
OP seems to enjoy rolling tubes and dialing in his sound. Is 2a3 really an affordable way for him to go?
Search the auction site for the Inspire amps that Dennis Had founder of Cary Audio is selling. You may have to search the sold listings. They sound much better that they should given the price. Single ended, class A, hand wired point to point, made in USA and can use a lot of different pentodes. 5-12 watts depending on the tube compliment.
Edits: 03/09/16
Actual do enjoy tube rolling, kind of what got me into tube equipment in the first place, kind of amazing to me how you can vary the sound. The Dennis Had Inspire amps look really nice, there is one (that I saw) up on the auction site. As far as 2a3 amps go, any commercial makers give you the option of running 2a3 or 45 in the same amp? I know the voltages are different, so there would have to be a jumper or something to change it, but it seems like a cool option if available!
Dennis does build 2A3 and 45 amps. So far I'm resisting. The pentode amps are simply excellent. I also bought a 27 tube triode preamp that is dead quiet and very affordable.
Fi Audio (Don Garber) in Brooklyn offers 2A3/45 stereo and mono amps, with just a change in the rectifier. But the wait time is very long. No better deal around.
Mine have a switch for 45 vs 2A3.
For my 95db Straight 8s, I preferred a 300B amp. The 2A3 just didn't quite have enough gas in a larger room and the 45s really need speakers that are up in the 100+db range to do them justice.
-Rod
This is important. Big room...you may need more sensitive speakers
So is the kind of music. If your music pretty much all sounds like "I don't want to be a hero", you will be OK.
The more complex the music, and/or with dynamic peaks, the more sensitive the speakers you need.
Easy to drive (high impedance) speakers can also trump some sensitivity.
I agree with Rod. You really need the right speakers for flea power to shine.
Maybe this is sacrilegious but I've supplemented my SETup with 2x10" powered subs. Maybe I'm lucky but they seamlessly integrated. Before I did this I listened mainly to bebop and acoustic music, mainly blues everything else that needed a bit more power was flat with poor dynamics. Now everything is enjoyable, a bass guitar actually sounds and feels like one. Especially my live recordings have seen a fantastic improvement.
I have to somewhat agree. I had the Tekton M-Lore for about a year and the 95db efficiency rating might be a tad optimistic. Ran it with a P-P 40 watter with excellent results. Your 300B suggestion would be as low in power as I would go ( roughly 8-10 watts) for reasonable SPL's.
Frihed89, thanks for the information about speakers. I will look into amps using those types.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: