Audio Asylum Thread Printer
Get a view of an entire thread on one page
|For Sale Ads|
In Reply to: RE: Recone alternatives for Yamaha/Eminence JAY6130 basket posted by BofService on October 28, 2012 at 13:42:46
OK, the pre-assembled cone kit came in and I installed it Tuesday evening. Not difficult at all. After a dry fit test I applied the adhesive, dropped in the kit and installed the shim. Nothing to it. The glue is dry now and it seems to work perfectly, though not yet tested at the power level it would see in production. No reason to think this was not completely successful. As I mentioned before, the effort to clean off the old parts and adhesive was much greater than anything else.
Have you measured the new system and compared it to your measurements of the old system?
How does it compare?
No, I have not measured. It was blown when I got it so I have no baseline. I could do a WT3 sweep if that would be helpful to anybody out there.
Post a Followup:
Post a Message!
This post is made possible by the generous support of people like you and our sponsors: