|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
71.112.216.180
In Reply to: RE: The Easy Button posted by AbeCollins on September 18, 2020 at 17:08:45
Thanks
Since I have to drill through the hardwood floor upstairs, and then through six or seven rafters downstairs, I don't want to drill a hole large enough for the RJ-45 plug. I'll cut off the plug and only drill a 5/16 hole to pass the cable through. I have a crimper to re-attach RJ-45's at the far end.
The remaining cable I'll use to make patch cables to run to the access points (2) from the Ethernet switch.
Follow Ups:
... of attaching a plug after pulling the wire, consider putting on a RJ45 jack instead, and then running a patch cord from the wall jack to the device. I find RJ45 jacks a bit easier to install than crimping a new plug on a cable.
I just did this at our new house when I wanted to move the AT&T gigabit router from one room to another.
IMHO, the hole size difference is not that great but that's obviously a personal decision.If you want to drill a smaller hole then crimp a new RJ45, you will definitely be better off with solid conductor cable as the crimp-on RJ45 is not meant to accept stranded wires..... as best I can tell. My RJ45 crimp connectors are meant for solid.
Edits: 09/19/20
"as best I can tell. My RJ45 crimp connectors are meant for solid."
They do make plugs to crimp stranded cable also.I have used them, but prefer solid cable. When you look closely at the stranded connector the tines in the connector pierce the wires whereas the solid crimp wraps around the conductor.
View YouTube Video
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: