Audio Asylum Thread Printer
Get a view of an entire thread on one page
|For Sale Ads|
In Reply to: RE: Unfortunately posted by E-Stat on March 05, 2017 at 07:29:27
The Etcher flash tool will be able to flash the SD card...less than a minute.
You already have LMS running somewhere?
If not you can actually set PiCorePlayer to run both LMS and Squeezelite.
Everything else should be a snap.
Good luck and if you have any problem just let us know.
I first installed the burning tool found in the initial link and it was unable to "lock" the device for imaging.
I found and installed the Etcher tool which worked like you said. I think I'm ready to go!
Yes, I've been using LMS for some years now.
While I use a uRendu in the main system, the RPi will replace the last of my Touch players located in the garage system.
All you need to do once powered up is to:
1) Enter the Picoreplayer ip address in your web browser
2) Select the "Squeezelite Settings" tab
3) Use the pull down to set your output device
4) Let Squeezelite Restart
Picore will auto-magically connect to LMS and you're jamming.
I gather I must wire it to my router for initial configuration and setting WiFi WEP before I can turn it loose. I noted a WiFi tab in the PiCoreplayer settings.
Yes, just use the WiFi Tab and enter your router password etc., it reboots and done.
You might have to hard wire it via ethernet first to get access from your browser.
Dynobot, does this Pi setup include an onboard DAC (mezzanine card), or do you drive an external DAC via USB? thanks
You can choose to buy on On-board DAC board for the Pi or just buy the Board with digital outs to use your own DAC.
Thats not my Pi, but it looks like it has the HiFiBerry Digi+ board on top. Which means its set up to use SPDIF output.
...will sound grand!
Post a Followup:
Post a Message!
This post is made possible by the generous support of people like you and our sponsors: