Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
24.184.225.216
In Reply to: RE: Help needed: Tympani IVa midrange driver problem posted by Roger Gustavsson on April 09, 2021 at 06:35:41
Roger-
Since my mids were recently rebuilt at the factory, I'm planning on another approach (that doesn't require replacing or re-wiring the mylar) to move the magnet/perforated panel closer to the mylar (and closer to flat). This weekend I'll be testing to see if adding cross bars at 2 or 3 locations to the rear of the panel, pushing it closer to flat (but not quite there, per Magnepan). If that raises the output level, I'll route out some grooves in the MDF panel to mount the bars, which will also help hold the panel in place.
I'll post my progress.
Thanks,
Mike
Follow Ups:
I would've thought 4 positions would be necessary, for the stiffness & length of the mid panel?
And presumably these crossbars should not be made of steel?
Andy
andyr wrote:
"I would've thought 4 positions would be necessary, for the stiffness & length of the mid panel?
And presumably these crossbars should not be made of steel?"
Why not steel if stiffness is required? The slightly curved back of my T-IVa mids are stiffer than any other of my Magnepan drivers.
But now I think about it, Roger ... Magnepan used steel crossbars on my Maggie bass panels - so it can't be a problem!
Andy
Andy-
I'll experiment with the number of braces. Aluminum is usually my choice when doing metal work, as it's easier to machine. As a side benefit, it's not magnetic.
Mike
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: