Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
73.139.76.161
In Reply to: RE: Here you go posted by Satie on June 13, 2017 at 18:08:49
I have the feet but only enough for four panels. There are no holes drilled in the outboard bass panels.
When separating the mid/tweeter panel, should I unscrew the hinges from the frame or try to pull the hinge pins?
Follow Ups:
I looked at the panels again and there are only holes for the feet drilled in the center panels. No holes at all in the mid/tweeter panel, and the holes that are there on the outboard bass panels are in the center of the panel rather than on the outside edges like on the center panel.
If I am going to separate the mid/tweeter panel, it looks like I need 4 more feet and then figure out where the holes are intended to be. These aren't new socks, so I am not sure why they wouldn't show up.
Yes on the hinges the screws would come off entirely.
On my panels there are holes on the bottom for feet near the edges but they were not drilled through the fabric. you need to feel for them with your fingers. It is possible that your panels didn't have them drilled, but so far I have not found anyone with Tympani panels without the holes for feet on their edges. If they were not used then the fabric would not be perforated over them.
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: