Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
67.189.82.60
In Reply to: RE: First Watt B4 arrives today - setup questions for Tymp I-Ds posted by Davey on April 22, 2017 at 20:54:10
Exactly Dave. For the op's Tympani T-1, a symmetrical 1st-order x/o is required for both the high and low pass filters. At the time of it's original manufacture, the T-1 was being distributed by Audio Research, whose PC-1 passive x/o was designed expressly for that application. It created a 1000Hz x/o point, with four level controls, one each for left and right channels/high and low pass outputs.
Follow Ups:
I would hang onto that Dahlquist unit. That's a nicely conceived unit and could come in handy in the future.
Dave.
Good point Dave. That's why I still have the DQ-LP1! I kept my copy of Frank Van Alstine's plans for his upgrade modification to it. One thing to do is just not use the high-pass inputs---the capacitor is uses for filtering can just as easily be installed on the power amp input jacks, saving an extra set of inter-connects. Then use the active 3rd-order low-pass inputs only. That control has an adjustable frequency range, though not nearly as wide or precise as that of the First Watt B4.
Edits: 04/24/17 04/24/17
Well, it's hardly going to make any difference unless you have interconnects that are a mile long.
Installing the capacitor internal to the DQ-LP1 is preferred as it allows to use the shunting resistor location so you can fine-tune while still using standard value capacitors.
Dave.
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: