Audio Asylum Thread Printer
Get a view of an entire thread on one page
|For Sale Ads|
In Reply to: RE: Valencia undoing advice posted by Idler on June 18, 2017 at 15:39:21
I think what I'd do is to (you need a table saw) take your
1 x 1.5" piece and cut an "L" into one corner down the length
to fit OVER the existing piece. Just screw it on, pre-drill
holes so it won't split....plus you can always remove it to
go back to OEM.
Probably a wise move. Will have to mark and drill for both attachment to existing piece and for threaded insert for attaching horn. Nice suggestion. Thanks!
Might be a good idea to install a support bar from top driver
stud to top of cabinet to take some load off of the front horn mount.
Approx. 1/16" x 3/4" would do it.
Post a Message!
This post is made possible by the generous support of people like you and our sponsors: