|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
199.188.65.49
In Reply to: RE: Beyma sm115/k as sub posted by KanedaK on June 07, 2017 at 15:22:10
If you expect it to go much below 40hz, consider a tapped horn design.
Follow Ups:
According to what I've read it's not the best driver for horn loading. Is a "tapped horn" différent in its requirements?
A tapped horn in not actually horn-loaded in the bottom octave, it's a sort of tapered transmission line.It looks (in sims) to be a very good choice for a driver like yours for high efficiency deep bass.
An EV driver similar to yours.
This is a corner install, could even be behind a wall, in a closet, etc.
With no EQ, basically ±2.5dB 20hz~80hz.
With a couple of damped stubs (photo of a Danley), would go higher.
Edits: 06/08/17
I agree with this notion. That driver would kikbuti in a tapped horn.
Am I reading this right: 27 cubic feet ?
I will have to admit, a "tapped horn" is something I simply can not grasp.
In the few actual cabinet designs I have seen, there is an exit right next to the driver. I just don't "get it".
"Am I reading this right: 27 cubic feet ?"Yes, that's why I have installed large loudspeakers in another room, behind walls, etc (there is no such thing as a free lunch).
"I will have to admit, a "tapped horn" is something I simply can not grasp."
It's an old concept, dating back into the 40's. I believe Danley figured out how to model it in AkAbak, then McBean figured out how to model it in Hornresp.
Edits: 06/09/17
Back when I lived in Florida, I had two 17.5 cubic foot enclosures, each with DUAL 15's. 35 cubic foot total. That bass was almost as good as what I have now (Infinite baffle, 500 cubic feet).
My experience tells me there's no way around it. If you want SUPERB bass quality, be prepared for a very large amount of air behind a lot of cone area.
These current HT type subs pale in comparison, as far as sound quality for 2ch audio, but I suppose they are just fine for foot-stomps and explosions.
Given the choice between commercial HT subs, I'd rather do what KandK does with a legitimate woofer system using professional drivers.
I have four Big Danley tapped horn subs. Three of them are 3/4 of an arry of 4 butted together in a Chicago Imax theater.Great bass below 60 hz. is expensive. I spent half my system budget on subs and room EQ. It's flat at my sweet spot from 20-200 Hz. and it sounds good.
Edits: 06/09/17 06/09/17
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: