|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
173.171.53.137
In Reply to: RE: If you really want to hear what an amp like this can do posted by ahendler on April 14, 2017 at 19:24:27
Paul Eizik ;
Thanks for the suggestion . Do you know anything about their tweeter mod ?
I tried to email the DIY Soundgroup with no results . Are they on holiday or something ? Their Cinema 10 looked interesting but I could not find any flat pack information , there or at Denovo .
It has been mentioned , that just because a speaker has the required characteristics 16ohms , 100db. eff. and large volumetric box's , it may not play well with low power amps like the 2A3 . What else should I pay attention to ?
Thank you .
Follow Ups:
Oh and I forgot the big-o-woofers too !
Something else I was wondering about were folded horns and open back speaker designs . They seem to be 'an' answer to the large box requirement
but I see most of them implemented with small single drivers . None with large drivers. Why is that ?
Thank you .
Saki
I almost didn't see this because it's tacked on to Alan and Lawrence's discussion ; ) The Fostex T90 is a good tweeter and that's what was used on the BK10 I heard some years back. They are showing the BK20 plus T90 with an L-Pad to match the level of the tweeter (105 dB) to the woofer (96 dB), and they show a single capacitor (1.0 to 1.5 uF) as a simple crossover to limit the low frequency response of the tweeter. I would build it with a first order series crossover which would include an inductor coil to limit the high frequency output of the woofer, which would not be limited with just the single capacitor. So there's room for experimentation. Note that the T90 is shown on a dowel rod sled making it possible to get the woofer and tweeter in phase with each other by moving the tweeter back and forth to find the sweet spot. The speaker won't sound that different "dialed in" like this, but the stereo image will be much tighter with better instrument localization.
If you have a good 2A3 SET amp it should work fine with the BK20's. You don't say much about your amp, and I'm sure you'll get many opinions on that. I heard the BK10's with fairly powerful looking p/p pentode amp, but the BK20's are rated 96 dB and should be adequate for all but loud rock and roll with a 3 Watt 2A3 amp.
Open baffle speakers come in all shapes and sizes but they are at an efficiency disadvantage compared to horns. They are also at a disadvantage in bass performance unless the baffle panel is very large. So with a 3 Watt SET an open baffle would be quite limited and you would likely need a subwoofer.
I'm unfamiliar with the Cinema 10's
Good Luck!
Paul
If you REALLY want to hear the beauty of this little tweeter, try it with an 18/db/octave high-pass.
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: