Welcome! Need support, you got it. Or share you ideas and experiences.
88.111.158.144
In Reply to: RE: Dragonfly posted by Robert Bastani on September 11, 2008 at 21:47:07
Thank you for the response. When you state that the exact size of the throat is extremely important, how " exact " is exact.
If the cabinet is modified for aesthetic reasons or differant drivers ( as you mentioned in previous threads ), how much leeway do you have in throat area before the function is compromised ? Besides the horn mouth mentioned in your answer , are there any formulas for the " throat, main volume, to horn entrance " in order to find the optimum throat area ? How did you derive it for your coaxial, or was it trial and error ? Is the horn length important ?
Hope you can answer
Roy
Follow Ups:
Hello Roy,
i found the dimensions by trial and error (i use tuneable cabinets for the design, by this i only need to build a few cabinets). DF is a mixture between bass reflex and horn. The volume of cabinet and tuning frequency of the horn is similar to a bass reflex- design. When you plan to adapt this for another driver you need to find specific dimensions for this cabinet- part for the new driver. The horn which follows also works for other drivers of the same size when the systems resonance of the "reflex" partition is similar to the DF values. The DF cabinet uses floor and rear- wall to simulate a big sized hornmouth - the mass of air which is moved by the driver thru the horn and the virtual opening increases a lot and lowers the resonance of the system, so the basses are much more fundamental than other compact horn designs offer. The aim of the DF cabinet design was to get a slim speaker offering deep AND dynamic bass response and also a simple cabinet building for diy. All the factors (driver parameters, reflex partition, dimension of the horn and the virtual mouth formed by the room)take influence, each parameter interacts with all others - highly complexed. For your individual design adapting other drivers of the same size the first steps should be finding the right volume and the right tuning frequency (horn lenght and entry diameter), when this is right you may use the contour of DF to get a satisfying result.
Regards
Robert Bastani
Hello Robert
Thank you again for your reply
Roy
Hi Robert
would it be possible to combine the dragonfly with the ultratweeter?
cheers,
Bernhard (yes the one in Dublin ;)
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: