Audio Asylum Thread Printer
Get a view of an entire thread on one page
|For Sale Ads|
In Reply to: RE: Pass Labs INT-250 posted by Bill O'Connell on March 15, 2017 at 14:21:02
Only one hernia for me! LOL
It has arrived! Hooked up and playing, oh yea
whom do you represent as a Distributor/Rep ?
I had installed some caps ( Duelands & CMR Clarity caps ) into my speaker crossover
and decided I didn't want to burn out my tubes while burn in was happening on the caps.
One of my good friends Wayne recommended that I build the ACA mono-blocks from the DIY forum. I had asked him about best inexpensive SS amp to purchase for this project without breaking the bank.Nelson Pass simple circuit and bar none probably the best amplification for the $287 delivered to your door was his answer. Two days to build and I was so shocked at how good these little mono's were, albeit 6 watts. Wayne has the XA600.8 mono's from Pass Labs. To make a long story short, I was looking for a higher wattage SS amp as Eastern Electric has never made a SS amp.After Wayne recommended the 250.8 I decided that was the SS amp I wanted.Read everything I could on it three times over and pulled the trigger on purchase.
Nice system- Bill.
Very nice- Bill.
Crossover caps will form in a matter of a few hours. Done.
Too much is never enough
Congrats. I know the feeling! :)
Post a Followup:
Post a Message!
This post is made possible by the generous support of people like you and our sponsors: