|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
120.148.112.108
In Reply to: RE: So if your aim is to have "less clutter and fewer Interconnects" ... posted by ahendler on April 05, 2012 at 07:39:20
And another poster said he need to use a SUT with that cartridge, with the Monbrison ... which the OP wants to avoid. Hence my suggestion of a diferent preamp - such as the tweaked Doge 8.
Regards,
Andy
Follow Ups:
This is from the a report on the up graded Doge 8
" The upgrade allows the
phono section to accept moving coils with an output of .25 mV or greater, straight in, without
a step-up transformer.
So this wouldn't work either
Alan
From memory, I think I looked at the dB gain figure and concluded it should be fine.
Well, I guess those who decide to use absurdly LOMCs deserve the hassle they cause themselves! :-))
Regards,
Andy
I don't know about the upgraded Doge, but the previous version had a pretty noisy FET MC stage. Objectionably noisy with my .25mV Denon.
The phono stage performed much better with an external SUT. With the latter it was quiet, though not as noise free as my ARC SP16.
I liked the Doge - a smooth, dynamic full bodied sound - but ultimately it didn't 'gel' in my system. Internal build quality/soldering was...well, 'dodgy'. Nowhere near the quality of the ARC in this respect.
System Details
Interesting that it should have been noisy. I have a JFET phono stage which is dead quiet ... though that's perhaps bcoz each channel is powered by 2 x 12v SLAs?
Regards,
Andy
I think a FET head amp should be quiet - otherwise was is the point. To me it appeared to be an afterthought.
System Details
The other gentleman mentioned a Dyna 10.5 cartridge which has an output of 2.5mv which the Monbrisson should handle just fine. The op cartridge I agree would not be a good match for the Monbrisson, but I would still rather get a good stepup tranny and keep the Monbrisson then go for another preamp. The Shindo pre's and phono stages are quite special
Alan
Me, I would use a battery-powered head-amp than a SUT, any day. (Which I need to use for my 0.28mV Benz LP into my 34dB MM phono stage.)
Regards,
Andy
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: