|
Vinyl Asylum: The Voice of Music site has the idler for $28 with trade-in! nt by alaskahiatt Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
For Sale Ads |
97.45.129.20
In Reply to: RE: I reworked the platter bearing, and it works fantastic. posted by John-from Seattle on September 19, 2018 at 06:02:36:
nt
This post is made possible by the generous support of people like you and our sponsors:
Topic - Paging ghost of olddude55 - alaskahiatt 18:30:30 09/17/18 ( 12)
- RE: Paging ghost of olddude55 - John-from Seattle 08:17:42 09/18/18 ( 10)
- John, I did press the side of the platter today, and it continued - alaskahiatt 19:08:56 09/18/18 ( 6)
- RE: John, I did press the side of the platter today, and it continued - John-from Seattle 21:21:02 09/18/18 ( 5)
- I reworked the platter bearing, and it works fantastic. - alaskahiatt 00:01:28 09/19/18 ( 4)
- RE: I reworked the platter bearing, and it works fantastic. - John-from Seattle 06:02:36 09/19/18 ( 1)
- The Voice of Music site has the idler for $28 with trade-in! nt - alaskahiatt 09/19/18 17:44:07 09/19/18 ( 0)
- It takes 1 minute, 33 seconds for the platter on my 1019 to stop from 33 1/3 rpm. - ghost of olddude55 04:10:53 09/19/18 ( 1)
- My table only goes for one minute after the switch goes from STOP to neutral. nt - alaskahiatt 11:03:09 09/21/18 ( 0)
Thanks John and olddude. To me, the idler is in good condition. - alaskahiatt 09:40:01 09/18/18 ( 2)
- What kind of prices did you see of NOS idlers? - ghost of olddude55 10:44:58 09/18/18 ( 1)
- Most prices I saw were around $75 and $90 at LPgear. - alaskahiatt 19:01:26 09/18/18 ( 0)
No noise here, not since I cleaned and oiled the motor bearings. - ghost of olddude55 03:36:05 09/18/18 ( 0)