|
High Efficiency Speaker Asylum: RE: Altec Model 19 clone with a twist by BillWojo Need speakers that can rock with just one watt? You found da place. |
For Sale Ads |
76.116.63.99
In Reply to: RE: Altec Model 19 clone with a twist posted by maroudasgeorge46@gmail.com on February 16, 2021 at 14:27:53:
WTF george! No need to be rude. I was pointing out an obvious error in your setup and didn't know if you realized it. BTW, 511E were built by modifying the 511B, they cut off the flange, bored it out to 1.4" and drilled it for the 3 bolt large format pattern. After shortening the tapered throat the flange was welded back on. Not uncommon for DIYers to do it themselves.
Have you asked the folks on the Altec forum about attenuating the signal to the horn driver? Your attitude won't go far there either so take a chill pill. It's only audio my friend.
BillWojo
This post is made possible by the generous support of people like you and our sponsors:
Topic - Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 12:21:06 02/16/21 ( 14)
- RE: Altec Model 19 clone with a twist - Rod M 08:49:28 02/17/21 ( 0)
RE: Altec Model 19 clone with a twist - Coner 13:00:41 02/16/21 ( 12)
- RE: Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 14:05:55 02/16/21 ( 10)
- RE: Altec Model 19 clone with a twist - Coner 14:26:20 02/16/21 ( 0)
- RE: Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 14:13:09 02/16/21 ( 8)
- RE: Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 14:16:09 02/16/21 ( 0)
- RE: Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 14:15:15 02/16/21 ( 6)
- RE: Altec Model 19 clone with a twist - BillWojo 14:25:16 02/16/21 ( 5)
- RE: Altec Model 19 clone with a twist - maroudasgeorge46@gmail.com 14:27:53 02/16/21 ( 4)
- RE: Altec Model 19 clone with a twist - GM 15:03:03 02/18/21 ( 0)
- RE: Altec Model 19 clone with a twist - BillWojo 02/16/21 14:36:57 02/16/21 ( 2)
- Altec made a step-down adapter......... - Alpha Al 13:51:42 02/17/21 ( 1)
- RE: Altec made a step-down adapter......... - jad 07:22:53 02/18/21 ( 0)
RE: Altec Model 19 clone with a twist - edgilfus 14:01:20 02/16/21 ( 0)