Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: NTE No Clean Solder Braid, in a class by itself

Posted by B. Scarpia on January 14, 2021 at 12:54:23:
Other brands just aren't the same and are frustrating to use.

Both the Cat-A-Pult and my current electric I linked to down the thread are great for point-to-point but often leave solder in a PCB eyelet. Heating the lead on the new part and trying to push it through is hit or miss and can overheat the part.

Holding the braid with the iron to the eyelet and then introducing a bit of fresh solder just as if you were soldering the braid to the board, then pulling/rubbing an inch or two of the braid along instantly clears the hole. I'd need prehensile toes to do that with a bulb type.

As others have posted, a solder station is desirable; my Hakko is nearly old enough to vote and invaluable especially when you need to bring the thunder like tinning heavy solid core wire for ground buss or tinning that pesky Cardas with each strand urethaned.

With great power comes great responsibility, though; especially beginners should be careful and stay in the 700 degree range for nearly all tasks. Using the higher heat to quickly get on and off which is preferred, takes some practice.