|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: going to upgrade some caps, maybe some advice needed
Posted by Cougar on January 13, 2021 at 14:29:13:
These are the 6 film caps that go under the PCB correct?
Do you have some already soldered in place? If so, and you want to keep the originals without damage to them there are two ways. With the lead in the grasp of pliers, you can heat the soldering pad and gently pull on the lead until it comes out of the solder joint pad. Or you can cut the leads and do the same with less issues. Then you can go back and clean out the rest of the solder in the hole with either solder Wick or one of those cheap desolder hand sucker pump.