Home
AudioAsylum Trader
Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: I usually leave the LP in the pouch for 12 hours.

Posted by flood2 on July 18, 2020 at 16:25:47:

Are you using the original pouch with the 12V plug pack? Those had quite a wide range for the controlled temperature (PTC element), so what works for you may be dangerous to the vinyl for someone else. It sounds like your pouch could be on the cooler side.

I used to do similar to you with heavyweight vinyl (mainly because I forgot to turn it off!). Then I found some formulations were badly damaged - I lost about 3 records around Xmas time which was annoying because I hadn't even played them!

Unless you have measured a representative temperature between the rings for what temperature the vinyl would be exposed to and know that it is no higher than around 54°C or so, then the overnight duration should be safe. Otherwise, I would recommend that the temperature be measured between the rings after at least 2 hours (because that's how long it takes for the plattens to heat up to steady state), then make the decision as to the maximum time. I suggest even then leaving it for no longer than a further 2 to 2.5 hours after steady state (for a temperature around 54°C). If the temperature is nearer to 60°C, I would keep the time shorter to no longer than around 2 to 2.5 hours in total, before cooling down.

In practice you only need to take the record near to the heat deflection temperature to reset the shape so leaving it for long periods is actually unnecessary unless the pouch temperature is cooler than 54°C.