Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Height adjustable isolation feet for my VPI HW-19 Mk 2

Posted by Music Man Bob on April 17, 2017 at 14:16:53:
Hello Sidewinder and another great idea. I did go to Home Depot and purchased a pack of 5 (five) 10/32 bolts. However, when I tried to screw them into the bottom of TT case. The bolts were too small. As a matter of fact, I think the pieces the 10/32 bolts screw into had been removed from each of the 4 holes. So, since I don't know what the pieces are that should be screwed into the holes and then will be able to hold the 10/32 screws, I am at a lost now. The only other alternative is to purchase 4 flat top adjustable isolation footers. Does anyone know what the pieces are called that can be screwed into each of the 4 holes that would actually hold the 10/32 bolts? Where can I purchase them from? Thanks all.

bob