Tubes Asylum

Questions about tubes and gear that glows. FAQ

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Re: Anyone know how to "open up" a Kora Triode preamplifier?

Posted by Max on April 7, 2001 at 20:55:51:
John--You must remove the three screws across the top of the back and all 4 screws on the front panel. Its wierd and when you pull the cover off be careful because there are some sideways protuding tabs on the back --it a juggle act and I cut the tabs off after all the mess of juggle. Its a nice pre amp and good value but the last piece of Kora stuff for me --two dealers got the run around when I asked for a schematic and whoever distributes them is real stupid ot downright deceptive since several request for schematic resulted in owners manual first and then a stupid pictoral but no schematic. For me Audio Res is not as good value but at least they back up for tech people like me. No matter haw bad Kora is it can`t hold a candle to Goldmund what wanted me to send my SRA amp to Switz for service --the module went out and they will NOT supply. I am too old for that kind of Mickey Mouse stuff. Max