Tubes Asylum

Questions about tubes and gear that glows. FAQ

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

EL38 in a Cronus II magnum

Posted by oreillyreally on September 9, 2023 at 15:04:03:
I have been using EL38 (instead of EL34) in my Rogue Cronus II Magnum for a bit, but am wondering if I have adjusted the bias properly. For the EL34 I had it set to 30, but with the introduction of the EL38, I had to increase the amount on the dial to get it to even show any amount. I have it set to 20 for the EL38 but should have left it set to the previous or reduced the bias by half and then inserted the EL38, even though I the meter doesn't register anything (I hear that one should maybe even reduce the bias by 2 times of the EL34 @30, but am again not sure how to proceed). There is no red plating, distortion or the like, just a clear reproduction, actually better than the previous NOS EL34 they replaced...