Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Dennis, you never answered the question.

Posted by Tre' on July 3, 2017 at 11:57:22:
I think if he was PP guy he would a uneducated/ignorant PP guy, in much same way as he is a SE guy.

RoTM = run of the mill?

If so then I strongly disagree.

He's SE amp is poorly designed from the power supply to the driver stage to the operating point and load impedance of the output stage.

"Run of the mill" stuff is better than that!

Tre'