|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: hot amp switch box
Posted by cpotl on June 7, 2017 at 06:25:47:
Sorry for the poor image quality, but attached is a sketch of the sort of thing I had in mind. Two ganged 3-way Make-Before-Break switches, wired as shown. I've had a couple of beers (in China right now, where it is evening), but I think it does the job of ensuring neither amplifier ever operates with no load, and that the two outputs from the A and B amps can never be connected together as the switching occurs. The indicated positions of the switches are for Amp. A playing through the speaker. The middle position is neither A nor B playing through the speaker. R would be 8 ohms or so. Of course another 2 gangs are needed for the other channel of a stereo amplifier.
The schematic assumes it is allowable to have a common ground for the outputs from amplifiers A and B. If this is not allowable (e.g. circlotron OTL amplifiers) then I suppose it would need a similar switching arrangement for the other end of the speaker too.
I could imagine there are more efficient ways to achieve the desired goals, but I think this would achieve it (unless the beer was too much!).