Home
AudioAsylum Trader
Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: update.....

Posted by vinnie2 on May 31, 2017 at 14:35:50:

I think I see what you are saying...bring everything to the top of the resistor that will have the one wire going to the plate connector. I suppose that could work. I never looked at it before because I did not have the resistor hooked to the pin. I will have to look at it carefully to see how it will fit under the chassis, but it would be nice to have only the one wire going from the resistor to the plate connector on the outside. I just hope there is room to do it. Thanks for the tip.