|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
update.....
Posted by vinnie2 on May 31, 2017 at 12:41:25:
Ok, before making any changes I want to make sure I have it straight this time. I have gone back over the posts and suggestions and this is what I came up with.
1. Per Tre', the 200 ohm resistor needs to be moved to as close as possible to pin 3. The wire from the resistor will still have to go externally to the plate connector on top of the 813 as there is no connector for the plate on the tube socket.
2. The other wires will still all need to be external to the plate connector on the top of the tube because there is no connection to the plate on the tube socket.
The plan is to get the resistors placed correctly, and then I will measure the operating points for voltage and currents to see where we are there.
Does that sound right to everyone?