|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: voltage drop
Posted by vinnie2 on May 31, 2017 at 08:59:50:
Actually the 350 vdc (now 340) was measured between the end of the resistor next to the cap on the 813 and ground, so it should be the same as mearing between the plate and ground. I just realized I really should have checked and written down all the operating points before putting it in place in my system. I will have to try and measure them where it's at I guess, as it is a heavy sucker and the less I move it with my bad back the better.