|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
the label bias is a negative voltage
Posted by pix on April 3, 2017 at 23:28:29:
@Paul
Yes the label "bias" in this schematic is a negative voltage even though I have miss to wright it down.
The LL1664 is configured as a 3000:8 ohm load.
The amp sounds fine, no question about that. But that does´nt mean it could not be make sounding even better.
My curiosity was pointing at the input and the E280F driver, with the aim of increase sensitivity and decrease the source load.
Is it adviceable to try the driver as a pentode to lower the miller cap?
Change the 25K volume control for a 100K dito?
Increase (or remove) the grid leak resistor?