SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Regarding CCS

Posted by Ralph on October 15, 2021 at 11:25:51:
I don't use a CCS in single-ended circuits so I can't comment, but I use them in differential amps all the time and I do have this to say:

Most CCS circuits I've seen are detrimental, because they leave performance on the table and often have linearity problems. I solved that issue about 25 years ago by implementing a 2-stage CCS in our circuits. By having 2 stages it could be referenced to ground at one end- so it knew what 'quiet' was supposed to be; at the other end it was referenced to the power supply, so it could suppress noise from the power supply as well. You really do need a 2-stage CCS to get the job done.

In our amps the power supplies were not regulated. So the performance was affected by line voltage. With the CCS installed as described, the performance of the voltage amplifier circuit was unmeasurable with the line voltage variable from 105VAC up to 130VAC. The CCS over that range varied in performance by 17 parts per million. That's pretty sweet- works really well to reduce noise and distortion while increasing gain.

I can't speak to use in single-ended circuits.