|
Small Boat Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
Re: homemade outboard
Posted by KenOhki on March 20, 2003 at 00:18:01:
That thing inside, If I am not mistaken, is round chunk of kinda hard rubber. ( at least on the props I have seen ) as far as I understand, it helps absorb shock and allows for it to wobble minutely without comming all apart or vibrating. I believe it is called a bushing. Yes, the shear pin or post behind the prop and the coter poin hole in front both need to be drilled through the shaft. In the back you need a strong Pin, this is what will have to stand up to you torking down the shaft nut
About your grinding to size. I would determin the size bolt that fits through the hole of the prop, then drill your guide to that size. I would make a note of how snugly the bolt fits in the hole, and keep that in mind when checking the shaft. Personaly, I would want the shaft fitting in the guide hole just a smigeon snugger then the bolt does, seams to work for me when I use the dye.good luck with your grinding.