Small Boat Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Re: 9.5 lower unit

Posted by akendall on October 7, 2002 at 13:03:40:
jtrnr50,
Water in the gear lube is a serious issue - especially if allowed to remain in the lower unit for a long duration (rust + heat + friction = worn out gears). Yes, you probably need seals. If you're mechanically inclinded you may be able to perform the task yourself, but it's tough - get a manual if so.
I would suggest taking it to a mechanic if you don't match the profile above - get a pressure test on the lower unit, then the mechanic can replace the needed seals when the leg is off. This has it's advantages because you will/should be covered under a warranty if the job isn't done correctly!
Last bit of advice - get the mechanic to replace the water pump while the lower unit is off - should only cost about $20 and the labour has already been done to get at it while replacing the seals...
~Andrew