Small Boat Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Re: looking to modify a 12 ft alum Jon boat

Posted by TAILGUNNER on October 3, 2002 at 18:27:50:
Hi, I have a fiberglass jon boat 14 feet. Mine is a rather deep hull design. I measured and made ply wood floors covered in grey outdoor carpet. I made a mount from aluminum and added a trolling motor and mounted 3 pedestal swivel seats. The boat had a cooler in the center bench I added a pump and made this an aerated live well., running the hoses out the rear drain plug hole with plastic plumbing fittings. I got my ideas from looking at bass boats. The hardware is readily available and easy to install. My boat went from plain jon boat to a kind of budget bass boat. I added bait lights and running lights etc to suit my needs.I had to fabricate a switch panel and wiring harness. as I said switches and wire etc are at any auto parts store or marine outlet.look around for Ideas